wimboot and Hyper-V

Hello again!

Observed on a Hyper-V server:

Guest VM with a Legacy (PXE enabled) NIC:

iPXE Loads, and will deliver a wide variety of images (CentOS, RedHat, SUSE 11) without issue.

But when using wimboot, v0.9x-v1.0, when the wimboot wim image load finishes, the guest crashes immediately and reboots.

Using wimboot v1.01-1.02 the wim image load completes, but gets stuck at a blinking cursor.

VMware-based guests served from the same iPXE TFTP and Webservers do not exhibit this issue and go on to boot the wim successfully.

Thoughts or ideas for troubleshooting?

Best,

Matt